Effects of Surface Morphology on the 3D Topological Insulator Samarium Hexaboride

ORAL

Abstract

The recent verification of a topologically-protected surface state in SmB$_6$ at low temperatures has led to several transport studies of the surface states. This task is complicated because current can flow on all surfaces of a topological insulator, each of which can have different transport characteristics. Our own measurements using a Corbino disc geometry overcome this difficulty, limiting the conduction to individual surfaces. However, the sheet conductivities of our samples counter-intuitively decrease with finer surface polishing. We therefore investigate surface and sub-surface morphology as a factor affecting the surface conductivity. Specifically, surface cracks may themselves harbor surface states and contribute to the total electrical conduction, yielding a higher measured sheet conductivity than that of a flat surface. This situation may contribute to the (sometimes unphysically) large surface conductivities already observed in SmB$_6$.

–

Authors

  • Steven Wolgast

    Dept. of Physics, University of Michigan, Randall Laboratory of Physics, University of Michigan - Ann Arbor

  • Yun Suk Eo

    Dept. of Physics, University of Michigan, Randall Laboratory of Physics, University of Michigan - Ann Arbor

  • Cagliyan Kurdak

    Univ of Michigan - Ann Arbor, Dept. of Physics, University of Michigan, Randall Laboratory of Physics, University of Michigan - Ann Arbor

  • D. J. Kim

    University of California at Irvine, Dept. of Physics and Astronomy, University of California, Irvine, University of California, Irvine

  • Z. Fisk

    Univ of California - Irvine, Dept. of Physics and Astronomy, University of California, Irvine, University of California, Irvine